Location: Home > IEC standards > IEC 61169-60-2021 pdf Radio-frequency connectors – Part 60: Sectional specification for RF coaxial connectors with push on mating – Characteristic impedance 50 Ohm (type SMPM)

IEC 61169-60-2021 pdf Radio-frequency connectors – Part 60: Sectional specification for RF coaxial connectors with push on mating – Characteristic impedance 50 Ohm (type SMPM)

IEC standards 11-29
IEC 61169-60-2021 pdf Radio-frequency connectors – Part 60: Sectional specification for RF coaxial connectors with push on mating – Characteristic impedance 50 Ohm (type SMPM)

5 Quality assessment procedure 5.1 General Clause 1 0 of IEC 61 1 69-1 :201 3 applies to this sectional specification, except as follows: Subclauses 5.2 to 5.4 provide rating, performance and test conditions to be considered when writing a detail specification. They also provide an appropriate schedule of tests with minimum levels of conformance inspection sampling. 5.2 Rating and characteristics (see Clause 5 of IEC 61 169-1 : 201 3) The values indicated below are required for SMPM series RF coaxial connectors unless otherwise stated and are given for the writer of the detail specification. They are applicable for the condition when the connectors are fully mated. Certain tests may not have requirements and this is indicated by a blank or NS (not specified). These requirements shall be specified in the detailed specification by the manufacture of the connector. These ratings and characteristics serve as the input in preparing the detailed specification, describe what shall be mandatory, and what is up to the discretion of the manufacturer. Preferred climatic categories are given in Table 1 0. Ratings and characteristics are given in Table 1 1 .
6.3 Performances 6) Performance data listing the most important characteristics of the connectors in accordance with the requirements of the relevant sectional specification. Deviations from the minimum requirements shall be clearly indicated. Non-applicable parameters shall be marked “na”. 6.4 Marking, ordering information and related matters 7) Insert marking and ordering information as appropriate, together with details or related documents and any invoked structural similarity. 6.5 Selection of tests, test conditions and severities 8) “na” shall be used to indicated non-applicable tests. All tests marked “a” by the detail specification writer shall be mandatory. When using the normal procedure with a dedicated BDS, the letter “a” − for applicable − shall be entered in the “test required” column against each of the tests indicated as being mandatory in the test schedule of the relevant sectional specification. Any additional tests required at the discretion of the specification writer shall also be indicated by an “a”. The specification writer shall also indicate, when necessary, details of deviations from the standard test method and test conditions, including any relevant deviations given in the test schedule of the sectional specification.

Download